Vaillant Boiler Repair Service
Expert Gas Safe Registered Vaillant Boiler Service and Repair Specialist
This was another Vaillant TURBOmax Plus 828E I worked on this week, this one being a repair of a faulty printed circuit board. this was a job for a customer of mine who lives in S70, Barnsley, South Yorkshire.
This boiler is installed in a fairly large house and the customer actually has 3 of them which service various parts of the house.
This was a little service I did on a Vaillant TURBOmax Plus 824/2E I did for a customer in Doncaster in recently.
I don’t work on as many of these old TURBOmax’s anymore, there are still quite a few around but they are getting replaced and are slowly being phased out for newer high efficiency condensing models.
This was a Worcester 350 Combi boiler I repaired September 2018 – today actually in Hillsborough, Sheffield, S6. This is not the typical boiler I work on daily, in fact over the last four and a half years I have only worked on two.
This was a service/repair job I did for a customer today in Rotherham, S61. Ive been looking after this particular boiler since 2015.
It has been well looked after by myself, and I don’t think it had any issues up until this point.
This was a much needed repair of a second generation Vaillant ecoTEC Pro 28 Combination boiler, in Hillsborough, Sheffield, S6.
The boiler in this case would attempt to fire up and then go to a blank screen for a period. With these boilers and the older glowworms, if the screen is blank then you typically disconnect all the connections from the board and se if the display lights up.
Read More “Vaillant ecoTEC Pro 28 faulty printed circuit board”
